MODULE 3 CHAPTER 5 QUIZ 5




Question Number. 41. A ni-cad battery found to be below normal capacity should. 
Option A. have its electrolyte adjusted.
 Option B. be removed and used for ground use only. 
Option C. be re-charged with a freshening charge. 
Correct Answer is. be re-charged with a freshening charge. 
Explanation. See Jeppesen's Aircraft Batteries .................................. 

Question Number. 42. In cold weather, to prevent the electrolyte freezing, a battery must be kept. Option A. fully charged. Option B. does not matter. Option C. fully discharged.
Correct Answer is. fully charged. Explanation. Checkout www.amplepower.com/primer/winter/ .................................. 

Question Number. 43. The internal resistance of a battery off load compared to on load is.
Option A. the same.
 Option B. increased.
Option C. decreased.
Correct Answer is. the same.
Explanation. Internal resistance is constant, regardless of load .................................. 

Question Number. 44. Two 12V, 40Ah cells in series gives. Option A. 24V 80Ah. Option B. 12V 40Ah. Option C. 24V 40Ah. Correct Answer is. 24V 40Ah. Explanation. Cells in series, voltage doubles, Amp hour rating remains the same ................................. 

.Question Number. 45. A 24V 40AH battery discharges at 200mA. How long will it last?. Option A. 400 hours. Option B. 300 hours. ... Option C. 200 hours. Correct Answer is. 200 hours. Explanation. 200mA goes into 1A-5 times. 5 * 40 = 200 hours .................................. 

Question Number. 46. The electrolyte level of a ni-cad battery. Option A. falls during charge. Option B. falls during discharge. Option C. rises during discharge. Correct Answer is. falls during discharge. Explanation. The electrolyte level of a nicad battery falls during discharge (but the s.g. remains constant) .................................. 

Question Number. 47. When light energises a component, what is the component?. Option A. Light emitting diode. Option B. Photodiode. Option C. Laser diode. Correct Answer is. Photodiode. Explanation. NIL ..................................Question Number. 48. Formation of white crystals of potassium carbonate on a properly serviced Ni-cd battery indicates. Option A. over charged. Option B. full charged. Option C. under charged. Correct Answer is. over charged. Explanation. NIL .................................. 

Question Number. 49. Thermal runaway causes. Option A. violent gassing only. Option B. violent gassing, boiling of electrolyte and melting of plates and casing. Option C. no gassing, but boiling of electrolyte and melting of plates and casing. Correct Answer is. violent gassing, boiling of electrolyte and melting of plates and casing. Explanation. NIL .................................. 

Question Number. 50. A primary cell. Option A. can not recharged. Option B. can be recharged but only a few times. Option C. can be recharged. Correct Answer is. can not recharged. Explanation. NIL. ...

Comments

Post a Comment

Popular posts from this blog

What is AC Generator? Modern AC sources are, almost exclusively, induction generators, where the principle of work is based on electromagnetic induction. In this case, the electromagnetic current is obtained by rotating the conductors in the magnetic field. Today, almost all alternating current generators are three-phase. This means that in their movable part, which is called a rotor, they have three separate coils, placed between each other at an angle of 120◦, in which three EMC are phase-shifted precisely by 120◦, or in time sequence for a third period. Coils are usually indicated by the letters R, S and T, each of which defines a single phase. Depending on the binding of these coils, the transmission of electricity from the generator to the consumer is carried out with 4 or with 3 conductors. If at the beginnings of all the coils are bound at one point (the so-called zero point), then we are talking about star connection. In that case, the other ends of each coil, are connected wit
Read more

MODULE 3 CHAPTERR 3 QUIZ 1

03. Electrical Terminology .................................. Question Number. 1. If a photon radiating into an electronic device causes the production of an electron/hole pair, the device is known as a. Option A. light emitting diode. Option B. laser diode. Option C. photodiode. Correct Answer is. photodiode. Explanation. NIL .................................. Question Number. 2. Faraday's Law States that. Option A. the magnitude of the EMF is indirectly proportional to the rate of change of flux. Option B. the magnitude of the EMF is directly proportional to the magnetic flux. Option C. the magnitude of the EMF is directly proportional to the rate of change of flux. Correct Answer is. the magnitude of the EMF is directly proportional to the rate of change of flux. Explanation. NIL .................................. Question Number. 3. Which of the following is 1 Amp?. Option A. 1000 mA. ... Option B. 1000 kA. Option C. 1000 μA. Correct Answer is. 1000 mA. Explanation. NIL .
Read more

EASA MODULE 13 AIRCRAFT STRUCTURES AND SYSTEMS

                EASA MODULE 13 AIRCRAFT STRUCTURES AND SYSTEMS SUB-MODULE 01 THEORY OF FLIGHT  SUB-MODULE 03 AUTOFLIGHT                                                                            (ATA 22)  SUB-MODULE 04 COMMUNICATION / NAVIGATION                                       (ATA 23/34) SUB-MODULE 05 ELECTRICAL POWER                                                             (ATA 24) SUB-MODULE 06 EQUIPMENT AND FURNISHINGS                                        (ATA 25) SUB-MODULE 07 FLIGHT CONTROLS                                                                (ATA 27) SUB-MODULE 08 INSTRUMENTS                                                                        (ATA 31) SUB-MODULE 09 LIGHTS                                                                                      (ATA 33) SUB-MODULE 10 ON BOARD MAINTENANCE SYSTEMS                              (ATA 45) SUB-MODULE 11 AIR CONDITIONING AND CABIN PRESSURISATION       (ATA 21) SUB-MODULE 12 FIRE PROTECTION           
Read more